In the process of using the slitter equipment, if there is improper adjustment, there may be some abnormal phenomena, and some damage to the product will be formed.

In the process of automatic slitting machine slitting, a more common problem is that the appearance of the product has burrs. This may be because the radial cutting depth of the disc cutting edge is too small or the axial vacancy is large, it may also be because of long-term use, the cutting edge has severe wear, should be timely grinding or replacement. In addition, it may be because the working strip violates the tension at both ends of the center line, which is caused by more burrs.

Secondly, in the production process of the automatic slitting machine, it may also be found that there is a wave edge on the shear surface of the strip steel, this situation is likely because the automatic slitting machine in the slitting process, the uncoiler, the disk shear, and the coiler are composed of three points against the center, which may be the uniform vacancy size of the straight axis of the cutting edge surface. It may also be because the material strip wave shape is severe.

In addition, during the operation of the fully automatic splicing unit, the staff can adjust the speed parameters provided in the electrical system by adjusting the automatic balancing and manual continuous adjustable functions. Together in the automatic slitting unit, the electrical system is equipped with automatic plate speed detection and automatic display system. The communication frequency conversion equipment of the system equipment is equipped with an input reactor to reduce the pollution on the power network side.