The slitting machine is used for slitting leather, cloth, plastic, and film. It is necessary to select the appropriate roll core according to the width and number of slitting, and correctly install it on the winding shaft of the slitting machine equipment. There is still a certain operating process for its operation. Operators need to learn these operating procedures in order to operate the slitting machine correctly. Below, we will provide a detailed introduction to the specific operating procedures of the slitting machine.
Operation process
1. Based on the width and number of slits, select the appropriate coil core and correctly install it on the winding shaft of the slitting machine equipment
2. Press the pressure roller onto the surface of the winding roller, align the knife edge and the joints of each core tube on the winding shaft to facilitate locking the lower knife
3. Pay attention to adjusting the upper blade shaft of the slitting machine, and the threading of the substrate should refer to the process route. It is not allowed to make arbitrary changes to avoid affecting the working effect
4. Connect the power to the slitting machine equipment and idle for about five minutes. Remember not to accelerate too fast, but slowly. Pay attention to checking for any abnormal issues during this process
5. After the speed reaches normal, pay attention to checking the cutting effect of the slitting machine equipment, and the staff should keep a good record of the operation
6. After the day's work is completed, the staff needs to turn off the power supply of the slitting machine in a timely manner and clean the work site.