What are the factors affecting the size of the sizes of the slitting machine?

With the industrial development, the slots are widely used in all walks of life. I believe that many friends encounter problems in the width dimension of the strip in the cutting machine cutting process, then affect the strip-to-range size What are the factors? The following small bracelets take everyone together to understand the key to the problem.

01 During the operation of the splitter equipment, if there is a problem with a horizontal swing, it will result in poor occurrence, such as the horizontal swing of the tool and the outer diameter scale of the tool. Because the horizontal swing value of the tool can be zero. Usually its landscape rocking value is from about 0.03 to 0.05 mm. The reason is that the precision error of the knife, inner diameter, distance sleeve, and the warpage of lateral stress when the thick plate shear.

02 During the docking machine device, since there is a problem with lateral warpage in the steel sheet, there is a poor width scale. This is because the product is larger when the product is measured when the product is measured in the horizontal warpage.

03 Because of the production of the separator equipment, there is a certain cooperative error in which distance sleeves, tools, and the like are required. Typically, the thickness accuracy of the distance, the tool, etc. is 0.005. When the cutting knife is more, the cumulative error becomes large. This is because the predominant setting is poor. It is important to know that the width of the width of the balanced article is slightly smaller than the actual situation of the product side scale of the knife. Therefore, the demand predicts this degree of underparation. Refer to the scale determination of the distance sleeve when the product side is frozen. It is also necessary to consider the selected shear method. In contrast, the splitter device uses a straight-handed cut, then the steel roll tension is increased, and the horizontal warp will disappear, and the scale will go down.

The equipment is not only guaranteed by all stability, but it can be maintained smoothly during production. Another pressure balancing device is equipped with a bilateral pressure equalizing the surface. In addition, the finished machine finished volume tension control system has also been improved, and then it can ensure the tightness of the finished product.