Sub -cutting machine failure exclusion method

1. Q: What should I do if there is a beating of the scroll?
Solution: Adjust the three -point concentration bearing and contact the scroll at the same time.

2. Q: What should I do if the main motor does not turn?
The solutions are: 1. Specific stop -stop buttons. 2. Connect the three -phase power supply and check the main circuit to connect the loose point. 3. Fix or replace the frequency conversion button switch.

3. Q: What should I do if the automatic correction power indicator is not bright and the indicator light is not on?
The solution is: replace the 1A insurance core.

4. Q: What should I do if there is no automatic correction, and there is no action without automatic manual?
The solution is: 1. Replace the 5A insurance core. 2. Please refer to the instructions for automatic correction

5. Q: What should I do if I am correcting?
The solutions are: 1. See the instructions for automatic correction. 2. Provide roll materials according to the requirements of rectification. Q: What should I do if I tighten the roll paper core? Answer: Adjust the appropriate collection tension.

6. Q: What should I do if the segments are not available?
The solution is: 1. Replace the paper core that meets the requirements of the inner diameter. 2. Use the closing voltage roller during the scroll. Q: What should I do if there is no action with the rolling roller? Answer: The solution is: 1. The air pressure is 4-5kg/C㎡.2, replace the airway switch. 3. Re -adjust the stream valve.

7. Q: What should I do if I don't turn the ear fans?
The solutions are: 1. Reset thermal relay restart. 2. Restore three -phase power 380V.

8. Q: What should I do if the roll material starts?
The solutions are: 1. Adjust the appropriate volume tension. 2. If the high -quality segmentation is required, the requirements for the segmentation material itself should be high.

9. Q: What should I do if I cut the roll materials?
The solution is: 1. Adjust the appropriate collection tension. 2. Use pressure rollers and cut the section bag over the pressure roller before entering the roll paper core.

10. Q: What should I do if I do not allow me to count?
The solutions are: 1. Trip -to -plan two -wheeled two -wheels contact the feeding rubber roller at the same time. 2. Make a mark on the rice wheel for 5 laps as a record of 1 meter, otherwise the meter meter will be replaced.

11. Q: What should I do if my tension cannot reach the tension?
The solutions are: 1. Remove mechanical failures. 2. After confirming that tension current is large, and tension adds new magnetic powder 5G to the brake or clutch.

12. Q: What should I do if I have no tension?
The solutions are: 1. The tension switch is placed in the "ON" position. 2. Adjust the tension to the right position. 3. Adjust the switch and detection block to 2-3 <> m m. 4. Replace the magnetic powder power amplifier, 5. Replace the magnetic powder brake or clutch, and reinterpret the drop. 6. Replace close to switch.